Been stripping an engine down i'm fitting in my 240z.... Its a Datsun/Nissan L28(2.8 IL6) SOHC.

How much would I be looking at for;

Block dip+clean
6 cylinder 1mm overbore
Crank regrinid(very very slight wear on the bearings/crank)+ balance, lighten

Also where would you all go in the Lincs/Notts/derby area?

I paid £50 for the re bore and hone.
£60 for the crank regrind.
That was for a 4 cylinder 5 bearing crank.
The clean was thrown in.

[Edited on 9/4/12 by Thinking about it]

Possibly a little bit far south, but my last head work got done by SEP at Kegworth. I was really impressed with their work. I got referred to them by an old racer who used to take all his engines there for blueprinting etc.

See what they can do for you, SEP Kegworth.

I don't know about prices though.

Bit too far North but give these guys a call

Link

Had rebore done + recon head here resonably priced

east lincs motorsport , doesnt need to advertise !!!

done my volvo stuff ace and cheap .

Cotterell is my local and they are quite reasonable.