Hi all

Got my car back from having dry sump fitted and now got some issues,

Previously the engine mount was to the sump, wrong I know as it was a cast sump as well so not a good idea,

The people who fitted the sump kit etc made a engine mount to replace it and now I cannot fit the bonnet on way out about 40 mm,

I purchased some lower engine rubber mounts but still no go, so looks like it's making some new engine mounts,

My question is I will line the engine up to the best position then make the mounts to fit, but what is the best able for a k series engine, as long as the sump is flat or angle of the engine? That I'm not sure about, any help on this welcome if not I'll just wing it I suppose,

Thanks

Sean

Personally I would use the sump to dictate angle. I assume there is a pickup point for the scavenge
pump of the dry sump system ? This needs to be at the lowest point, so if it's to one side angle the
engine slightly that way, if it's central then the sump should be flat.

thanks for the advice,