Hi all
Is there anyone out there that knows the correct torque settings for the arp bottom end bolts, and the arp flywheel bolts please
many thanks
Mark



[Edited on 8/12/12 by hootsno1]

The Duratec handbook recommends for the fly three steps to tighten

first to 50nm+-4nm

2nd 80+-4nm

3rd 112nm+-4nm

this is what I have used with my arp bolts

The instructions I have from ARP say 45 ft lb for con rod bolts

I tightened and released mine 3 times to ensure they had stretched properly

Follow the ARP specs not the haynes or duratec manual!

ARP bolt specs are all on their website, listed by thread size.

Thanks for your replays guys I have now found the correct settings.
Flack monkey do you still make the duratec fuel rails?

Yep, can still do fuel rails, no problem