hiya does anyone know what clutch i need. engine is out of rangerover and gearbox is sd1 5 speed. flywheel is also sd1. the end of input shaft on gearbox is alot smaller than where it should mate do i need spigot bush?????
also will landrover v8 slave cylinder fit and do the job cheers andy

can no one help?????

Andy

Yes, you need a spigot bush - though there may be the remnants of an old bush in end of crank, so check before knocking a new one in. Use SD1 clutch cover and plate. Whilst you are ordering them, suggest you order new clutch cover bolts and (if you haven't already) new flywheel bolts.

Contact someone like Rimmer Bros and ask them about LR slave.

HTH

ATB

Simon

[Edited on 13/10/04 by Simon]

cheers simon helped alot will give rim bros a call.