Board logo

Where to buy IVA friendly exhaust silencer
Dan. - 25/4/14 at 06:49 PM

Hi guys where can I source an IVA friendly exhaust can with nice rounded ends and 3" in / out for sensible money.
Any suggestions welcome :-)

mark chandler - 25/4/14 at 07:00 PM

R1 can ?

The inlet is around 2.75" and it will be quiet, then gut it when you have the ticket.

Oops just looked on eBay, they are now £50+ on eBay

[Edited on 25/4/14 by mark chandler]

kj - 25/4/14 at 07:21 PM

I have one which went through sva on a x-flow

Dan. - 25/4/14 at 09:30 PM

I don't mind spending a bit more money but also don't want to be spending £300 on a silencer. Something not too restrictive as my in give is 2 litre twin turbo....

kj - 25/4/14 at 09:34 PM

£30.00 plus plus postage

Dan. - 25/4/14 at 10:22 PM

Do you have a pic and measurements please

kj - 25/4/14 at 11:50 PM

Picture on my car will measure and post more tomorrow

kj - 26/4/14 at 08:09 AM

Overall length is 103cm can is 61cm long and 36cm in diameter.post a pic later

adithorp - 26/4/14 at 08:27 AM

quote:
Originally posted by kj
Overall length is 103cm can is 61cm long and 36cm in diameter.post a pic later


36cm diameter ! A typo I suspect.

OP, I think you'll struggle to find an off the shelf exhaust with 3" inlet (if I've read your original post right). Most are 2" and a few 2.25" ans 2.5"

Dan. - 26/4/14 at 09:31 AM

quote:
Originally posted by adithorp
quote:
Originally posted by kj
Overall length is 103cm can is 61cm long and 36cm in diameter.post a pic later


36cm diameter ! A typo I suspect.

OP, I think you'll struggle to find an off the shelf exhaust with 3" inlet (if I've read your original post right). Most are 2" and a few 2.25" ans 2.5"

You have indeed read it correctly unfortunately I chose to go with a silly engine with way too much power...

adithorp - 26/4/14 at 09:42 AM

Probably going to have to get a custom one then.

Try 907 on here. NTDWM but he' makes them and has good reports of his work... http://www.paulgooderham.co.uk

kj - 26/4/14 at 10:05 AM

2.25 pipe diameter, 36 was around the silencer

Dan. - 26/4/14 at 10:16 AM

I already have one a similar size thanks anyway.

adithorp - 26/4/14 at 07:46 PM

quote:
Originally posted by kj
2.25 pipe diameter, 36 was around the silencer


About 11.5cm diameter or 4.5" makes it quite a small can.

Dan. - 26/4/14 at 07:50 PM

Thinking one of these...
http://exhaustpartsuk.com/index.php?main_page=product_info&cPath=1321_1323_1329&products_id=962
Will just need to get a nice 90 bend with rolled end.