My Vortx has developed a coolant leak from the radiator due to part of the fan cowling touching the core and gradually grinding down the flat
aluminium tubes until one has a tiny hole:
Simple question: Is there any way at all to repair this or do I need a new radiator? I was wondering about just crimping it shut, maybe after
putting some kind of epoxy or liquid metal in the crack to help it seal but I fear it wouldn't work. Any other ideas?
Jb weld will do it. Just be pedantic about cleaning and roughening the surfaces first.
Lumiweld sticks should work well.
Thanks chaps. I might pinch it closed first then use something like that on it.
Crimping it shut and folding onto itself ahold suffice.
That's how ointment tubes are sealed...
Or so I think...
Yes but what is the operating pressure inside an ointment tube?
How much for a new radiator and how much to rebuild the engine?
Those figures should point to how to deal with it.
I would suggest trying lumiweld, aluminium solder. Then doing gradually longer journeys to see if it holds?..... but do you really want to be driving
wondering if on this journey the radiator fails???
If the repair fails it would only leave a hole as big as what was already there so I wouldn't see catastrophic coolant loss. In fact if I pinch
it shut first it would be even smaller. Also I could smell it instantly when it started leaking as I was going along so I don't think I would be
caught unaware if it did leak.
I think it's worth risking a repair but I haven't priced up a new rad yet as I'm not sure what rad it is exactly. If it turns out to
be very cheap to replace then I'll go that route.
^^^^ i agree. Worth chancing it, do you have coolant level sensor.
No I don't but as I say, with no windscreen, doors or roof I could smell it instantly when it started leaking so I think I'll know if the
repair fails.
I'd still like to identify the rad and price up a replacement though. It might be a Polo one from the size but it doesn't look like ones
I've seen on google.
quote:
Originally posted by 02GF74
Yes but what is the operating pressure inside an ointment tube?
How much for a new radiator and how much to rebuild the engine?
Those figures should point to how to deal with it.
I would suggest trying lumiweld, aluminium solder. Then doing gradually longer journeys to see if it holds?..... but do you really want to be driving wondering if on this journey the radiator fails???
It shouldn't happen again as the issue was that 2 of the clips holding the fan had slipped slightly so it leant into the radiator. I'm going to put cable ties round all of them so they can't move again.