The Project is fitted with a 1.6 Ford Sigma engine and the question relates to the plumbing of the bypass. In this case, the hot water pipe to the
heater has an electrically operated hot water valve controlled automatically from the climate control module. There could be a situation when on start
up in hot weather for instance, the hot water valve might be closed and this would prevent any coolant circulation until the thermostat opened.
What are your thoughts on having a permanent restricted bypass or indeed, any other solutions.
Thank you.
On the MX5 the heater matrix is always full flow and flaps used to regulate airflow. I didn't use the MX5 heater sytem but used the same principles and am going to do the same with my current MX5 based project. Both with 1.6 Mk 2 engines
Thank you Ian and nice to hear from you.
I think we'll be okay without any extra plumbing because there is a small bore take-off from the back of the head which feeds into the header
tank shown on the attached diagram and confirmed by looking at my engine. This should do the job when the heater valve is closed.
IIRC the original fiesta valve is 3 way, it should flow through the radiator when on hot, and bypass back to the lower/secondary hose when set to
cold.
There is no hot/cold flap on a mk4 fiesta heater, so this is the only heater control used on the original heater.
I take it your replacement a/c heater box uses a similar system, but with a 2 way valve?
I would also place the header tank lower hose into the radiator lower hose, with it into the top hose the radiator will always have some flow passing
through, and will slow down the engine warmup.
Dave
quote:
Originally posted by obfripper
IIRC the original fiesta valve is 3 way, it should flow through the radiator when on hot, and bypass back to the lower/secondary hose when set to cold.
There is no hot/cold flap on a mk4 fiesta heater, so this is the only heater control used on the original heater.
I take it your replacement a/c heater box uses a similar system, but with a 2 way valve?
I would also place the header tank lower hose into the radiator lower hose, with it into the top hose the radiator will always have some flow passing through, and will slow down the engine warmup.
Dave