Chaps,

Does anyone know what the thread is? I've measured the thread and it looks to be 9mm, but I'm sure it has the slightest of tapers.

When I spoke to mocal, they suggested drilling and tapping my remote filter housing and screwing it into that (there is a casting for the purpose) but I need to know the thread.

Thanks very much

ATB

Simon

I am fairly sure its 1/2 or 5/8 UNF, One is the oil pressure, and the other is the Water temp on the manifold.. I think the oil is the 1/2 UNF.


I used Greegauges, and their sender is 1/8NPT, however I got an adaptor from Real Steel for about £5.

However the adaptor thread wall is VERY thin.

Put the adaptor fully in the block FIRST. I used a couple of layers of PTFE tape to seal. THEN put in the Oil Pressure Transducer, out you will split the side wall of the adaptor.

Guess how I know!