Does anyone have a good supplier of exhaust sections? I need to make up my own system and need 90 & 45 degree bends, a 4 to 1 collector (1.5" to 22" and a pinto manifold plate although I could make my own plate without too much difficulty.

I am undecieded about using mild or stainless - any comments?

Any links to mail order? Huddersfield is a loooong drive from here!

or an hacksaw bihind your local friendly exhaust center ????

cut all the bits out u need, a removed exhaust usually contains plenty of good bits, bends ect that are as new but the box as rotted thru........

just a thought..

Newbie exhaust question: if you have a mild steel exhaust, what treatment do you have to do on it? high temperature paint on the outside? and anything on the inside?

ta