On Ebay right now is one of the best cylinder heads money can buy, complete and ready to fit. For all those looking to upgrade your Pinto (even with a standard bottom end)... this would be my 1st choice!

Do an Ebay search on Dave Brooks and you'll get there. (Can't be bothered working out how to do a link). I doubt that it will be cheap though....

NTDWM.

Link

my prediction is £ 428. let's see who is closest

£345,
Steve.

A good £450 i should think.

Considering a burton or vulcan one will cost you over £800 new.

I bet it goes for around £600...

£375.78 approx.

£435 ish

A nice head and how big are those inlet valves
or am I just being tainted by the tiny ones in the Zetec.

I reckon around £497.38 or there abouts

Raised ports are the way to go on the Pinto but how much better than a sorted injection head will it be. I would be surprised if it gets much over £500, but then I was surprised when my R1 carbs and pinto manifold fetched £333 on eBay.

Well its up to £500 already!

"Raised ports are the way to go on the Pinto but how much better than a sorted injection head will it be."


190bhp with only a Kent rally-spec cam....speaks volumes.

[Edited on 21/5/07 by Memphis Twin]

Im sure it is good but there are cheaper options. AMAC Engineering built Mookys head onto a 2.0 pinto and managed 180bhp at wheels on 2 rolling roads with twin 45's and less ££££.