I have acquired a set of carbs from a CB600 and they have a lot of pipes sticking out! on the inlet side there are two biggish pipes at the top and one 8mm pipe at the bottom that looks as if it is fuel. At the manifold side there are two double connections between the outside carbs tha have a pipe linking them but nothing on the outside connections. Can anyone help with what all this plumbing should be connected to to work on a Pinto?
TIA

Caber

Basically, apart from the fuel inlet, all the pipes are supposed to connect to the airbox. Conventional wisdom says, leave 'em open to the atmosphere.

At least that's what I did and it ran great (never went anywhere, just revved it up

I have a manual in PDF format for CBR600 carbs, it's 17Mb but I'm sure I could split it and email it to you..

Edited to say; Ooops, that's assuming you meant CBR

[Edited on 29/5/07 by UncleFista]