Hi Guys,

I have the following question:

I have a standard 1.8 16v Zetec engine, on this engine are a lot of vacuumhoses that run from the exhaustmanifold to a valve and some other electronic units and to the inletmanifold, o yeah i am going to keep the standard inletmanifold with injection and ECU.

Since i am going to use a st. steel exhaustmanifold (4:1) instead of the original that is on it i have to figure out what to do with all these hoses.

Can somebody tell me what i have to do!
Pictures/Diagrams are also welcome.

Thanks in advance.

Regards,
Sebastian.

I had i similar thing on my isuzu piazza, was told by isuzu that the pipe from exhaust to valve on inlet manifold could just be blanked of, so i did and could not notice any difference, hope this helps. kev.