I think my exhaust loks a bit puny compared to some out there. What are my options for getting something more bigger? 
It needs to fit crossflow and exit bodywork where it does now in order to re-use the hole in the side panel.
So I am looking for a 4 or 2 brancher out the side to then go to a bigger box.
Anyone make off the shelf pieces (in stainless) or is it custom job/prices?
Ta.
Exhaust
for example:
[Edited on 25/1/08 by 02GF74]
i quite like it as it is.
although i would straighten it out so its level
looks big enough
your obviously getting bored, build another car
[Edited on 25/1/08 by Mr Whippy]
I'd keep an eye out on the Caterham boards for someone upgrading to a better setup. I got hold of a great standard Caterham silencer to install
with my Zetec. The final setup was Westfield Manifold -> Homemade link pipe -> Caterham Silencer.
Cheers
The Robinhood one looks good and not too expensive, they might do a crossflow one.
See Link Below:
http://www.kitpartsdirect.com/page6.htm
quote:
Originally posted by MKMike
The Robinhood one looks good and not too expensive, they might do a crossflow one.
See Link Below:
http://www.kitpartsdirect.com/page6.htm