tried for ages now to find something in search but im no closer,
what im looking for is a DXF or DWG file for a blanking plate between the type 9 bellhousing and 1300 x flow,
if anyone has one it will be much appreciated

cheers chris
(the one below i believe is to go onto pinto but you get what im after)

Not being funny - but why do you need a CAD file... You can use the Type 9 bellhousing to get a good representation, dont cut anything and keep it oversize on sheet aluminium. Drill the two ~13mm holes for the locating dowels and work from there to get a plate that fits perfectly.

I've just done exactly the same for a Zetec - Type 9 plate to ensure no crap gets into the bellhousing. It's the second one I've made (the other is in the Locost) and it took about an hour tops.

Oh - and split it into two parts make it much easier to install and remove... To fit the one above you'd need to take off the flywheel.

JC

[Edited on 12/7/08 by SeaBass]

if i get the cad file i can just get it laser cut at work and save me time and ill know its spot on

Well... good luck!