Paul TigerB6
|
| posted on 31/3/09 at 04:58 PM |
|
|
Pipercross PX600 filters
Evenin all
Could someone tell me if the PX600 is supposed to come with the 3 sprung metal fittings that go on the backplate. I have finished cutting a blank
backplate for one today and the pack of fittings i have with the filter only have the thumb mechanisms and plastic retaining washers!!
Cheers
Paul
|
|
|
|
|
clairetoo
|
| posted on 31/3/09 at 05:33 PM |
|
|
The filter wont have the parts for the back-plate , and as far as I'm aware Pipercross wont sell you them either 
But I do have some at work - they are a standard Dzues fastener - I can send you some ?
Its cuz I is blond , innit
Claire xx
Will weld for food......
|
|
|
Paul TigerB6
|
| posted on 31/3/09 at 05:52 PM |
|
|
Typical Pipercross!!!
That would be fantastic if you could Claire - i'll drop you a U2U shortly.
Thats twice now the generosity of the forum members has bailed me (and the fellow member who's car it is!!) out in a couple of weeks. Big thanks
to both yourself Claire, as well as Warren (Big_Wasa) who sent me a Mikuni TPS for fitting tomorrow. 
Cheers
Paul
|
|
|
a4gom
|
| posted on 31/3/09 at 06:24 PM |
|
|
i recently rang pipercross as i had the clips for the back plate but had missplaced the screws over the winter. i may have been lucky but they sent me
3 new ones. 
Andy
Perfect planning prevents pi$$ poor performance!
|
|
|
clairetoo
|
| posted on 31/3/09 at 06:37 PM |
|
|
I tried to buy some a few years ago (I was doing a nice line in carbon back plates and airbox's at the time) and they just didnt want to know
But then I did want 50 .................
Its cuz I is blond , innit
Claire xx
Will weld for food......
|
|
|
