Mark Allanson
|
 posted on 5/8/02 at 10:30 PM |
|
|
Adaptor plates
Does anyone have any information about how to make up adaptor plates to match your chosen engine to a sierra (type9) gearbox. General principles will
do, I dont need engineering drawings (but they would be nice!)
|
|
|
|
|
stephen_gusterson
|
| posted on 6/8/02 at 08:09 AM |
|
|
One method i have had described is that you cut up two plates to match the gearbox and engine. you need to ensure they are parrallel and in line.
Then, you cut up a series of 3mm or so steel plates, and weld them patchwork style between the two.
atb
steve
|
|
|
