coyoteboy
|
| posted on 23/10/11 at 09:27 PM |
|
|
Anyone aware of a 3D model of the Audi V8s?
Looking for a 3D model of the audi 4.2 V8 (ABZ or similar) to work with but can't find one. Anyone got any secret hidden repositories of
drawings? 
|
|
|
|
|
sheepish0001
|
| posted on 24/10/11 at 08:50 AM |
|
|
Been looking for one of these for ages as ive got a set of plans that i want to test fit the engine into,
Closest ive gotten is really vauge but
The approx sizes of the Audi ABZ V8 engine and gearbox are: -
Total length (Audi ABZ engine + 01X gearbox) = 1200mm (47 1/4"
Length of engine (front pulley to bellhousing face) = 490mm (19 3/16"
Length of 01X gearbox (bellhousing to rear casing) =710mm (27 15/16"
Max width of engine (across exhaust manifolds) = 760mm (29 15/16"
Max height of engine (sump to idle air valve) = 660mm (26"
Drive shaft position (front pulley to centre of drive flange) =690mm (or from gearbox rear casing = 510mm) (20" (27 3/16"
http://www.motorgeek.com/viewtopic.php?f=6&t=19049&start=25
huge amounts of Info Including the copy/pasted stuff above about allsorts of V8's
Shaun
|
|
|
coyoteboy
|
| posted on 29/10/11 at 09:01 PM |
|
|
Cheers. I've got one in the post so I'll measure and draw up a model when it lands 
|
|
|
sheepish0001
|
| posted on 29/10/11 at 09:39 PM |
|
|
That sounds brill you going down a nice mid engined route?
Sheep
|
|
|
coyoteboy
|
| posted on 29/10/11 at 09:48 PM |
|
|
Yup, finally made a decision. Middy monster
|
|
|
sheepish0001
|
| posted on 29/10/11 at 09:54 PM |
|
|
cool i have plans for about 5 midi cars just want to be able to squeeze that lovely engine in
Sheep
|
|
|
coyoteboy
|
| posted on 29/10/11 at 09:56 PM |
|
|
It's just a shame the laser scanner at work is too small to fit the engine in
|
|
|
sheepish0001
|
| posted on 29/10/11 at 10:02 PM |
|
|
just take it to pieces first 
Sheep
|
|
|
coyoteboy
|
| posted on 29/10/11 at 10:24 PM |
|
|
Ha. not with the cost of gasket kits for them!
|
|
|
