ReMan
|
| posted on 30/3/12 at 12:53 PM |
|
|
Propshaft UJ bearings (Sierra/BEC)
How many needle rollers in each joint?
www.plusnine.co.uk
|
|
|
|
|
Davg
|
| posted on 30/3/12 at 03:29 PM |
|
|
Ah Ha guess you dropped them when you took apart
off top of the head cant tell you the number, best place the remaining ones you got in the cap with a bit of grease & see if you have space. Then
grovel about the floor where you split the joint
cheers D
------------------------------------------------------------------------
|
|
|
adithorp
|
| posted on 30/3/12 at 03:45 PM |
|
|
quote:
Originally posted by ReMan
How many needle rollers in each joint?
a. A lot
b. More than you've found
"A witty saying proves nothing" Voltaire
http://jpsc.org.uk/forum/
|
|
|
ReMan
|
| posted on 30/3/12 at 07:46 PM |
|
|
Was it that obvious 
I've retrieved plenty, but I cant decide whether ther should be a 1 proller space or not?
www.plusnine.co.uk
|
|
|
Chippy
|
| posted on 30/3/12 at 10:02 PM |
|
|
If you have enough to fill it leaving just one space then you have the lot, more space than that then get on your hands and knees. Cheers Ray
To make a car go faster, just add lightness. Colin Chapman - OR - fit a bigger engine. Chippy
|
|
|
rusty nuts
|
| posted on 31/3/12 at 06:57 AM |
|
|
If you haven't found them all try using a magnet in the area that you dropped them, an old speaker magnet comes in handy
|
|
|
ReMan
|
| posted on 31/3/12 at 07:13 AM |
|
|
So you can laugh a bit more....
I split another joint to have a count and borrow a needle to make up and did the same thing again 
www.plusnine.co.uk
|
|
|
.jpg)
