Dave Ashurst
|
| posted on 1/4/12 at 09:23 AM |
|
|
Advice pls - Rebuilding a worn ford 4 spd gearbox
How practical is it to properly rebuild a gearbox at home? Does it need special kit?
TIA
D 
[Edited on 1/4/12 by Dave Ashurst]
|
|
|
|
|
rusty nuts
|
| posted on 1/4/12 at 11:51 AM |
|
|
I've done a few at home years ago , IIRC the only "special tool" was a dummy layshaft that enabled the lashaft bearings to be
installed and held in place whilst the laygear is fitted. A piece of wooden dowel could be used if you can't get hold of a metal shaft
|
|
|
mark chandler
|
| posted on 1/4/12 at 03:27 PM |
|
|
Did one when 19 and knew nothing, easy
|
|
|
Dave Ashurst
|
| posted on 1/4/12 at 05:40 PM |
|
|
Thanks, I made a start dismantling this afternoon.
Lots of bits.
|
|
|
.jpg)
