Nickctp
|
| posted on 19/8/12 at 06:38 PM |
|
|
Looking for x flow!
Just totting up costs to see what is best so thought I'd see if anyone has got a 1600 x flow they are looking to sell? All considered but MUST
have sorted bottom end!
Cheers
[Edited on 19/8/12 by Nickctp]
|
|
|
|
|
Westy1994
|
| posted on 20/8/12 at 10:59 PM |
|
|
From reading your other thread, I think you mean must have good bores?, since the bottom end would really suggest the crankshaft etc etc....
Have you had your existing bores measured yet, you may well get away with a re-ring perhaps?.
|
|
|
Nickctp
|
| posted on 20/8/12 at 11:06 PM |
|
|
quote:
Originally posted by Westy1994
From reading your other thread, I think you mean must have good bores?, since the bottom end would really suggest the crankshaft etc etc....
Have you had your existing bores measured yet, you may well get away with a re-ring perhaps?.
Indeed it must have good bores but I want a sorted bottom end all in all as in I don't want to do or have to do any work there at all! I have a
good head so not to fussed there.
Not had them measured yet - I have a specialist coming tomorrow but don't think a re ring will do it tbh. So much play in the pistons - I know
they need to move but these wobble all over the show, 1 is very bad!
|
|
|
