aidan46
|
 posted on 26/6/13 at 01:37 PM |
|
|
megssquirt 2 problem.
Hi, im having problem with the ground for fuel pump relay. When i connect up wire from ecu. Pin 37 i think nothing happens. If i use a wire and earth
relay off chassis works fine. Bought the board already assembled. Priming pulse is also greater than 1 ect ect...i fact i have had it working
correctly before? When i switch the ignition on with the multimeter between fpump wire and earth, it dose seem to be making some sort of attempt to
switch,( resistance reading change on meter.) any ideas???
|
|
|
|
|
scudderfish
|
| posted on 26/6/13 at 03:45 PM |
|
|
Is this any help?
http://www.extraefi.co.uk/Pulse_Pump.htm
|
|
|
coozer
|
| posted on 26/6/13 at 03:57 PM |
|
|
Thanks Scudder, I was having that problem with the pump pulsing and fully understand it now.
Cheers,
Steve
1972 V8 Jago
1980 Z750
|
|
|
aidan46
|
| posted on 26/6/13 at 04:23 PM |
|
|
Thanks mate will try that...could that cause the output to not ground the pump or just operate erratically im wondering? Thanks
|
|
|
big-vee-twin
|
| posted on 26/6/13 at 04:24 PM |
|
|
pin 37 only earths the pump after MS sees the engine turning at cranking speed 300rpm or greater.
You do get an initial priming pulse when first switching on.
If the pump is pulsing you need to set MS type in software correctly.
Duratec Engine is fitted, MS2 Extra V3 is assembled and tested, engine running, car now built. IVA passed 26/02/2016
http://www.triangleltd.com
|
|
|
aidan46
|
| posted on 26/6/13 at 05:30 PM |
|
|
Right okay,i havnt actually tried cranking it as it wasn't giving priming pulse....will try to do this as well! Cheers
|
|
|
big-vee-twin
|
| posted on 26/6/13 at 05:57 PM |
|
|
You will need a fuel pump relay as per ms manual as current cannot be handled by the ms internals
Duratec Engine is fitted, MS2 Extra V3 is assembled and tested, engine running, car now built. IVA passed 26/02/2016
http://www.triangleltd.com
|
|
|
aidan46
|
| posted on 27/6/13 at 07:55 AM |
|
|
The engine runs fine if i ground the pump relay off chassis. I ran the mini terminal but no errors show. Anyone have a screen shot of how to set the
software configuration? Ta
|
|
|
