Fishface
|
posted on 31/5/15 at 10:05 AM |
|
|
Smelly silvertop zetec
My 1.8 silvertop stinks of fumes to the point where my clothes stink after a run in the car. I'm guessing it must be old and worn and perhaps on
its way out. Is this normal, is there a simple repair that can be made withe engine in place or is it time to upgrade?
|
|
|
BenB
|
posted on 31/5/15 at 10:15 AM |
|
|
Think of simple things first- split fuel line going into the engine from the pump? Lots of fuel hose sold is pretty rubbish when shown ethanol in
modern petrol and will happily split and spray a fine mist of petrol over the engine bay....
|
|
cliftyhanger
|
posted on 31/5/15 at 11:06 AM |
|
|
How are the breathers sorted??
|
|
Fishface
|
posted on 31/5/15 at 11:37 AM |
|
|
Breather is an air filter at the top and the bottom goes to a red bull can
Fuel lines look ok but will have a check. The smell though is more fumes than fuel though.
|
|
spiderman
|
posted on 31/5/15 at 11:47 AM |
|
|
Go on give us a clue, what do the fumes smell of? Oil, petrol,exhaust,fish, sh..,fa...? Might be able to give you a more definitive answer then.
Spider
|
|
Fishface
|
posted on 31/5/15 at 11:56 AM |
|
|
Probably exhaust type fumes. I was told at a garage that the silvertops do have a tendency to smell a bit when worn but it's getting worse. I
can turn the car off and push into the garage and the house will still smell of a fumes type smell from the car after a run. I have air bricks under
the floor that go into the garage by the way.
|
|
coozer
|
posted on 31/5/15 at 01:55 PM |
|
|
Smelly oiil out of the breathers??
1972 V8 Jago
1980 Z750
|
|
MikeRJ
|
posted on 31/5/15 at 04:02 PM |
|
|
quote: Originally posted by Fishface
Breather is an air filter at the top and the bottom goes to a red bull can
That probably answers the question as to where the stink is coming from. If the engine is getting a bit tired then the increased leakges past the
rings will be blowing out stinky oil vapours from your "breather" system. Why not vent them back into the air intake?
|
|
Fishface
|
posted on 31/5/15 at 04:45 PM |
|
|
I see, interesting. How could I vent it back. I'm running twin webbers.
|
|
austin man
|
posted on 31/5/15 at 04:53 PM |
|
|
you have breathers omn the engine originall the breather would have gone directly into either the exhaust or into the inlet and been burnt off, when
fitted to the kitcars we tend to have the breathers venting under the bonnet
Life is like a bowl of fruit, funny how all the weird looking ones are left alone
|
|
Fishface
|
posted on 31/5/15 at 05:41 PM |
|
|
right i see. Is there any suggestion on how to do this as I don't think my inlet or outlet have any connections available on them.
|
|
coozer
|
posted on 31/5/15 at 06:17 PM |
|
|
I joined the block breather and the one off the can cover with a T and ran the hose down to the floor.... And, breath....
1972 V8 Jago
1980 Z750
|
|
Fishface
|
posted on 31/5/15 at 09:52 PM |
|
|
That's a simple idea. Anyway just been into the garage and checked the block breather and the pipe had come off. Excellent.
I noticed a bit of oil on the block which seems to be coming from around the metal unit next to where the breather block exit is. Don't know
whether this needs the Allan key bolts tightening. What does his unit do?
|
|
austin man
|
posted on 31/5/15 at 10:32 PM |
|
|
I believe it is some type of trap which allows fumes up but not oil it may also some filtration
Life is like a bowl of fruit, funny how all the weird looking ones are left alone
|
|
cliftyhanger
|
posted on 1/6/15 at 06:51 AM |
|
|
Ideally you want both breathers going into a catch tank(they can share or be separate) and then the outlet of the catch tank going via a tube to exit
somewhere suitable, under the car? stuffed into an air intake on the engine? You really do not want to be dropping any oil on the road, that is rather
unfriendly and will be very unpopular if you take the car on track. For good reason.
|
|
Fishface
|
posted on 1/6/15 at 11:32 AM |
|
|
thanks guys. I will do something like that.
|
|