paul browne
|
posted on 29/1/05 at 09:19 AM |
|
|
bike engine locost
hi I am right at the start of my locost project and I am about to start collecting parts etc I have decided to use a fireblade engine and I was
wondering if there is a tried and tested way of getting the drive to the prop shaft + as a new builder with no experience are there any well known
pitfalls I should avoid, any advice will be greatfully recived.
|
|
|
Jon Ison
|
posted on 29/1/05 at 09:45 AM |
|
|
its tried n tested, buy or make a prop adaptor, use a prop with a center bearing.
if your building chassis yourself i would leave all the bars out of the engine bay and transmission tunnel till youv'e got all your oily bits
and you can then place these to suit.
Happy building n welcome.
|
|