contaminated
|
| posted on 21/3/22 at 12:20 PM |
|
|
Exhaust Collector
Hi all. Any tips for getting the headers into the collector? Unbelievably tight. Just can't get them in.
Tiger Super Six Independent
www.southernkitcars.com
|
|
|
|
|
nick205
|
| posted on 21/3/22 at 02:56 PM |
|
|
Interference fit?
Can you put the inner bit in the freezer to try and get the dimension to contract a fraction?
Put the outer bit in the oven to get the dimension to expand a fraction?
Take care holding hot metal obviously and get the two bits together quick so as not to lose the temperature affect.
|
|
|
roadrunner
|
| posted on 22/3/22 at 09:56 AM |
|
|
Or just gently heat up the female part with a torch.
|
|
|
contaminated
|
| posted on 23/3/22 at 12:48 PM |
|
|
I'll try those. Thanks chaps.
Tiger Super Six Independent
www.southernkitcars.com
|
|
|
Benzine
|
| posted on 23/3/22 at 01:08 PM |
|
|
quote:
Originally posted by roadrunner
Or just gently heat up the female part with a torch.
Tried your advice last night.
Slept on the sofa.
|
|
|
roadrunner
|
| posted on 23/3/22 at 07:45 PM |
|
|
quote:
Originally posted by Benzine
quote:
Originally posted by roadrunner
Or just gently heat up the female part with a torch.
Tried your advice last night.
Slept on the sofa.
 
|
|
|
