Fishface
|
| posted on 26/3/07 at 03:26 PM |
|
|
re: bike carbs
i need a choke cable. Any recomendations? Ive seen the one on kitcar solutions but im not sure if it has the right end bit to go in bike carbs?????
Can you recomend any cheap air filter suppliers aswell?
Cheers ROb
|
|
|
|
|
Danozeman
|
| posted on 26/3/07 at 03:45 PM |
|
|
Iv got a universal one on my bike carbs. U just need a push bike cable end on it. You can get removable nipples from most bike shops.
Dan
Built the purple peril!! Let the modifications begin!!
http://www.eastangliankitcars.co.uk
|
|
|
02GF74
|
| posted on 26/3/07 at 03:51 PM |
|
|
what is your nipple requirement?
I have some stainless steel bike gear cables going spare.
also how long?
|
|
|
BenB
|
| posted on 26/3/07 at 03:55 PM |
|
|
I also just got a universal jobby... Didn't have the nipple to put on the end but put a bolt through the nipple hole and clamped the cable
between two washers and tighten it up... Not much strain on a clutch cable after all....
|
|
|
grahamgg
|
| posted on 26/3/07 at 04:02 PM |
|
|
I dont think you will need a nipple ,just clamp it up at the choke end.
|
|
|
jacko
|
| posted on 26/3/07 at 05:24 PM |
|
|
i used the bonnet pull on the sierra column
|
|
|
Fishface
|
| posted on 27/3/07 at 12:24 PM |
|
|
My nipple requirement so to speak will need to be checked out. I presume its like the throttle bit and will take a bike brake cable type end.
thanks
rob
|
|
|
DarrenW
|
| posted on 27/3/07 at 01:57 PM |
|
|
Mac#1 have cable and a selection of ends in stock. That is where im getting mine from when the time comes.
|
|
|
Fishface
|
| posted on 28/3/07 at 01:10 PM |
|
|
What about air filters? do you recomend bogg bros??
|
|
|
DarrenW
|
| posted on 28/3/07 at 01:38 PM |
|
|
Ref filters - measure your centres and take a pic of the filter mounting face. then give Mark at Mac#1 a call. He had a pair of K&N's on the
shelf last week. I tried them but my spacing wasnt right so didnt buy them (im using ZZR1100 keihins).
HTH,
Darren.
|
|
|
