coozer
|
 posted on 1/4/07 at 03:11 PM |
|
|
Bike carbs and TPS
I have a set of ZZR1100 carbs that are fitted to my 1.8 zetec.
I need TPS for the Megajolt and am scratching my head how to achieve it as the carbs dont have one as standard. I was thinking of attaching the Ford
one to the throttle pedal but that doesnt look viable either.
Anyone done this before??
1972 V8 Jago
1980 Z750
|
|
|
|
|
rusty nuts
|
| posted on 1/4/07 at 05:26 PM |
|
|
Do you have a nut on the end of the throttle spindle ? I have an adaptor that screws on to fit T.P.S. that I won't be using . You will need to
make a bracket
|
|
|
coozer
|
| posted on 1/4/07 at 05:59 PM |
|
|
Theres no nut, just a push in plug and the end of the spindle is plain and 'under flush'
Steve
1972 V8 Jago
1980 Z750
|
|
|
DarrenW
|
| posted on 4/4/07 at 04:08 PM |
|
|
Steve - im thinking along the lines of rigging up a bracket with a pulley that is pulled by a cable attached to the carb throttle spindle pulley (it
looks like its designed for 2 cables). Spring to pull it back to rest position.
I was also wondering if the shaft could be drilled at the end and a spindle extension loctited in. Would be quite a small drilling though.
Other than that im at a loss as well.
|
|
|
coozer
|
| posted on 4/4/07 at 05:28 PM |
|
|
Yep, I reckon a 4mm hole and 5mm tap but there's not much room at the end to attach the TPS. The one I have is off the Ford inlet and its huge
against the carb.
I'm taking the plunge and changing mine to R1 jobbies with Blogg Brothers manifold.
1972 V8 Jago
1980 Z750
|
|
|
DarrenW
|
| posted on 5/4/07 at 07:49 AM |
|
|
Can i have your old carbs?
|
|
|
.jpg)
