Dave Bailey
|
| posted on 19/11/07 at 09:50 PM |
|
|
Engine mount Tube Dimensions
Need to make up some new Engine mounts because need to shift the engine over a bit plus my first attempt was done whilst learning with the old welder.
Need some advice of what type of mild steel tube I should use and wall thickness.
seamless? Diameter etc.......
Engine is a phase 3 zetec
thanks
Dave B
|
|
|
|
|
indykid
|
| posted on 19/11/07 at 10:38 PM |
|
|
i've used 40mm RHS when i remade mine in the indy. it's 3mm wall
it doesn't need to be seamless
tom
|
|
|
