LBMEFM
|
| posted on 4/7/08 at 12:59 PM |
|
|
Fireblade drive shaft flange
Sprocket now off and flange ready to bolt on with a spacer. Once in place and tightened up the problem I can see is how do you stop the prop shaft
bolts from turning when you do the nuts up. The bolt heads are inside the casing.
Barry
|
|
|
|
|
Howlor
|
| posted on 4/7/08 at 01:25 PM |
|
|
I think mine was tapped so no nuts.
Steve
|
|
|
ReMan
|
| posted on 4/7/08 at 01:32 PM |
|
|
I fitted the bolts from the outside and nuts on the inside.
Whatever though I have room behind it to get a spanner on the nuts......
Could it be fitted either way round?
Also I hav a substantial washer behind it to ensure the bolt tightens against the adaptor, they do vary.
[Edited on 4/7/08 by ReMan]
|
|
|
