dogwood
|
| posted on 5/10/08 at 02:24 PM |
|
|
What size exhaust pipe?
Hi
Further to my exhaust welding dilemma.
Can anyone please tell me what diameter piping to use on the 4 branch.
I am going into a 2" silencer pipe
The engine is a standard 1800 pinto.
I was thinking about 1.75" but looks a little big to me.
Also what wall thickness?
Cheers David
[Edited on 5/10/08 by dogwood]
|
|
|
|
|
Volvorsport
|
| posted on 5/10/08 at 04:07 PM |
|
|
38 x 1.5 wall .
www.dbsmotorsport.co.uk
getting dirty under a bus
|
|
|
dogwood
|
| posted on 5/10/08 at 05:47 PM |
|
|
Ta! 
|
|
|
jollygreengiant
|
| posted on 5/10/08 at 08:54 PM |
|
|
If you are doing it in Stainless, then the if you use the 38mm you will find that if you carefully dress one end of the pipe to a box section, if will
fit nice and snug into the oblong hole in the flange and then you just need to seem weld round the pipe/flange joint to make it a good'un.
I know 'cos that is what I did.
Beware of the Goldfish in the tulip mines. The ONLY defence against them is smoking peanut butter sandwiches.
|
|
|
