Blairm
|
| posted on 23/3/09 at 05:29 PM |
|
|
Crossflow Head Thickness
Hi
Can any one tell me if 81mm is a sensible thickness for a crossflow head?
The below auction has one listed at this.
http://www.trademe.co.nz/Browse/Listing.aspx?id=209062398
Can anyone tell from the photos if much porting has been done?
Thanks Blair
|
|
|
|
|
clairetoo
|
| posted on 23/3/09 at 05:42 PM |
|
|
Without knowing the diameters of the ports it's hard to say.......but it does look reasonable . Be handy to know the valve sizes , and weather
they are single or double valve springs .
Sorry - no idea on thickness 
Its cuz I is blond , innit
Claire xx
Will weld for food......
|
|
|
Dave-M
|
| posted on 23/3/09 at 05:49 PM |
|
|
head
81mm is good but I would be a little concerned vith the amount the valves are recessed into the head, could have been done to provide clearance rather
than machining the pistons.
Porting looks good.
Dave
|
|
|
Blairm
|
| posted on 24/3/09 at 12:17 AM |
|
|
Thanks guys, To slow it was sold
|
|
|
