theduck
|
| posted on 27/6/13 at 09:35 PM |
|
|
Twin 40s linkage
Mounted my twin 40s to the pinto manifold tonight and the spacing on the pinto manifold is different to the spacing on the XE manifold I took them off
so now the linkage between the two carbs is too short (see photo).
Suggestions on where to buy a suitably longer lever? Preferably west mids area so i can take the carb along and make sure i get the right one.
Or ideas to neatly extend it?
|
|
|
|
|
Mr Whippy
|
| posted on 27/6/13 at 11:32 PM |
|
|
A local fab shop, garage or blacksmiths could weld on a extension tab for peanuts.
|
|
|
benchmark51
|
| posted on 28/6/13 at 03:46 PM |
|
|
Mine was the same. I just extended it a bit and it works fine
|
|
|
