Mark Allanson
|
| posted on 19/7/03 at 08:33 PM |
|
|
Exhaust bits
Does anyone have a good supplier of exhaust sections? I need to make up my own system and need 90 & 45 degree bends, a 4 to 1 collector
(1.5" to 22" and a pinto manifold plate although I could make my own plate without too much difficulty.
I am undecieded about using mild or stainless - any comments?
|
|
|
|
|
Mark Allanson
|
| posted on 20/7/03 at 08:43 PM |
|
|
Any links to mail order? Huddersfield is a loooong drive from here!
|
|
|
Jon Ison
|
| posted on 20/7/03 at 09:26 PM |
|
|
or an hacksaw bihind your local friendly exhaust center ????
cut all the bits out u need, a removed exhaust usually contains plenty of good bits, bends ect that are as new but the box as rotted thru........
just a thought..
|
|
|
blueshift
|
| posted on 20/7/03 at 10:56 PM |
|
|
Newbie exhaust question: if you have a mild steel exhaust, what treatment do you have to do on it? high temperature paint on the outside? and anything
on the inside?
ta
|
|
|
