quote:

---

switch ignition on
immo lamp illuminates for three seconds under normal conditions
if it illuminates for one minute, wait and count flashes
the flash code consists of two groups of flashes (one set for each digit of the code) so * ** will be code 12
if you mis-count don't worry they are cycled ten times - or just start again

if the LED flashes rapidly the vehicle is immobilised

codes and definitions are:-

11 - immo control module not connected (wiring, reader coil connection, control module connection etc)
12 - immo control module not working correctly (duff immo module)
13 - key code not received or key programming failed (faulty key or key obscured)
14 - partial key code received (faulty or obscured key)
15 - key not programmed into immo module (reprogram or try different key)
16 - faulty link between immo module and ECU (wiring fault)
21 - less than three keys programmed (program more keys as necessary)
22 - ROM error - no ECU ID stored (duff ECU)
23 - ECU ID mismatch (duff ECU)
31 - code transmission error between immo control unit and ECU (wiring or ECU programming error)
32 - ECU/immo control unit comms - no response from ECU (wiring, immo control module)
33 - comms error (wiring, duff ECU or duff immo control unit)

---