spud69
|
| posted on 10/3/09 at 04:52 PM |
|
|
zx6r carb schematic
Before i start stripping my carbs does anyone have a schematic for the carbs, they are the zx6r series G carbs.
I've read that people have rebored the jets to 1.6mm is this necessary or should i see how / if it runs first.
Thanks...Andy
|
|
|
|
|
whitestu
|
| posted on 10/3/09 at 05:04 PM |
|
|
Hi Andy
I've just emailed them to the email link on your profile.
1.6mm was perfect for my 1.8 Zetec.
Stu
|
|
|
Paul TigerB6
|
| posted on 10/3/09 at 08:19 PM |
|
|
I've just dropped a spair set of 150's into a pair of GSXR 600 carbs to go on a standard 2L pinto - will see how it runs when i fit the
carbs tomorrow. The carbs are Mikuni and the jets are the same as those found in Weber's incidentally. I'd say get a set of microdrills
and slowly drill them out myself until it seems to run well enough
[Edited on 10/3/09 by Paul TigerB6]
|
|
|
mackei23b
|
| posted on 10/3/09 at 09:53 PM |
|
|
you'll get the diagrams from www.kawasaki.com
|
|
|
spud69
|
| posted on 10/3/09 at 10:19 PM |
|
|
Thanks All and Stuf for the diagrams...
|
|
|
.jpg){kind=avatar}
