mkeats02
|
| posted on 30/3/12 at 01:41 PM |
|
|
Zetec to Type 9 Starter Motor
Hi
I am fitting a type 9 gearbox and zetec engine to my Striker and have been looking at Starter Motors is the following suitable?
eBay - The UK's Online Marketplace
Just want to check before committing.
Cheers
Mike
|
|
|
|
|
AndyG
|
| posted on 30/3/12 at 01:58 PM |
|
|
Hi,
I bought that starter motor from them a few months ago its not the same as the one in the photo but I still have it so I will try a post of photo of
it tonight so you can see what you would be getting. It needs quite a bit of metal grinding away to get it to fit, therefore I found a slimer starter
motor that required far less grinding that seemed to fit ok and works fine.
|
|
|
r1_pete
|
| posted on 30/3/12 at 02:44 PM |
|
|
Try QX Components QS1221, mine was less than £50 delivered.
Pictures of it fitted in my archive under Engine...
|
|
|
AndyG
|
| posted on 30/3/12 at 03:51 PM |
|
|
That's what I used as well, seemed to fit well.
|
|
|
dlatch
|
| posted on 30/3/12 at 05:39 PM |
|
|
pete did you need to enlarge the mounting holes on that starter?
the main issue seems to be the sump fouling rather than anything else
|
|
|
r1_pete
|
| posted on 30/3/12 at 06:01 PM |
|
|
No hole opening up, but, for any starter using this config on a blacktop you need to remove a lot of alloy from the intermediate sump. In the end I
used a silvertop sump, it had a better profile, but still needed mods, I'm sure there are pics in my archive.
|
|
|
HowardB
|
| posted on 30/3/12 at 06:58 PM |
|
|
I have a second hand one, and spacer ring if you need £20 + postage,... if that helps, or you can collect from Leicester or Biggleswade
Howard
Fisher Fury was 2000 Zetec - now a 1600 (it Lives again and goes zoom)
|
|
|
