itsawindupuk
|
| posted on 3/4/12 at 05:41 PM |
|
|
me again!!!! Type 9 nose cone diameter
hi guys, me again, having to make a sleeve for the gearbox i was wondering if anyone knows the outside diameter of the protective sleeve around the
input shaft, needs to be pretty exact. I dont have one to measure at the mo.
Adam
|
|
|
|
|
clanger
|
| posted on 3/4/12 at 05:54 PM |
|
|
33.62mm
|
|
|
itsawindupuk
|
| posted on 3/4/12 at 06:26 PM |
|
|
thanks very much!
|
|
|
stevec
|
| posted on 3/4/12 at 06:56 PM |
|
|
Just checked a spare one I have in the garage and above dimension is correct but the bellhousing spigot is the large diameter on the nose piece I
think. I suppose the smaller one is machined off the bigger one so it should be close to centre.
Steve.
|
|
|
itsawindupuk
|
| posted on 4/4/12 at 06:20 AM |
|
|
Yeah unfortunately the spacer kit I bought doesn't have q way of aligning the box and bell housing.
|
|
|
