jeffw
|
| posted on 18/4/12 at 08:34 AM |
|
|
Mocal oil catch tank thread size
I have a Mocal 1lt tank I want to convert from 1/2" push on fittings to AN-10 but I don't know what the thread is on the 1/2 push fittings
where they go into the tank. The thread measure 12.9mm in diameter. Anyone know what it is?
|
|
|
|
|
HowardB
|
| posted on 18/4/12 at 08:44 AM |
|
|
could be 1/4BSP, that would be 13.15 on the OD,.. however I had something the other day that was M12 x 1.5, there are so many threads out there used
on similar stuff,...
is there any info on the Mocal website?
Howard
Fisher Fury was 2000 Zetec - now a 1600 (it Lives again  and goes zoom)
|
|
|
jeffw
|
| posted on 18/4/12 at 08:48 AM |
|
|
Nothing I could find. Don't think it is M12 as it is almost 13mm (12.97 on the vernier). Could be 1/4BSP
|
|
|
TheKingofBling
|
| posted on 18/4/12 at 08:56 AM |
|
|
Defo 1/4 BSP, done the same on mine Jeff
DIRTY DOGG RACING
|
|
|
jeffw
|
| posted on 18/4/12 at 09:17 AM |
|
|
Thanks
|
|
|
jeffw
|
| posted on 24/4/12 at 07:32 AM |
|
|
Spot on with the 1/4BSP. I had to run a 1/4BSP to AN-8 converter then AN-8 to AN-10 as the crankcase vent was a AN-10. All good now and no more oil
leaks from the PCV area (or dipstick).
|
|
|
