Duratec spigot bearing depth

Not logged in [Login - Register]

LocostBuilders » Forum » Engine & Transmission » Duratec spigot bearing depth

MIG Welders & ARC Welders at MachineMart.co.uk

Printable Version | Subscribe | Add to Favourites

mikey p

Junior Builder

Posts 73
Registered 27/10/11
Location Near Milton Keynes
Member Is Offline

Photo Archive Go!

Building: Westfield SEiW and 2.0T RWD Focus

posted on 28/9/14 at 08:42 PM

Duratec spigot bearing depth

Hi,

Any one know the depth that the spigot bearing should be installed into a duratec crankshaft when fitting to a type 9?
Is it all the way till it stops or a prescribed depth?

Thanks

big-vee-twin

193 HP Duratec Inside

Posts 2482
Registered 9/8/09
Location East Yorkshire
Member Is Offline

Photo Archive Go!

Building: Franky - ST150 2.0 Duratec GTS Panther

posted on 28/9/14 at 08:49 PM

Knock it in all the way, make sure the rubber seal is on the outside

Duratec Engine is fitted, MS2 Extra V3 is assembled and tested, engine running, car now built. IVA passed 26/02/2016

http://www.triangleltd.com

LocostBuilders » Forum » Engine & Transmission » Duratec spigot bearing depth

All content © 2001-16 LocostBuilders. Reproduction prohibited
Opinions expressed in public posts are those of the author and do not necessarily represent
the views of other users or any member of the LocostBuilders team.
Running XMB 1.8 Partagium [© 2002 XMB Group] on Apache under CentOS Linux
Founded, built and operated by ChrisW.