Oddified
|
| posted on 5/5/19 at 06:04 PM |
|
|
Which CV joints, 100mm or 108mm
I'm looking at assembling new/stronger drive shafts (welded shafts at the minute...fine while the engine is standard for now!), will the 100mm
lobro bolt on cv joints cope with say 500bhp and grip (drag racing with slicks as an extreme), or would it be better just to bite the bullet and go
for 108mm cv's straight away?.
Ian
|
|
|
|
|
40inches
|
| posted on 5/5/19 at 06:51 PM |
|
|
quote:
Originally posted by Oddified
I'm looking at assembling new/stronger drive shafts (welded shafts at the minute...fine while the engine is standard for now!), will the 100mm
lobro bolt on cv joints cope with say 500bhp and grip (drag racing with slicks as an extreme), or would it be better just to bite the bullet and go
for 108mm cv's straight away?.
Ian
I think you have answered your own question, do it once and do it right  
Saw your car at Stoneleigh, I was parked a couple of cars away. Very impressive build 
|
|
|
big_wasa
|
| posted on 5/5/19 at 07:00 PM |
|
|
quote:
Originally posted by 40inches
quote:
Originally posted by Oddified
I'm looking at assembling new/stronger drive shafts (welded shafts at the minute...fine while the engine is standard for now!), will the 100mm
lobro bolt on cv joints cope with say 500bhp and grip (drag racing with slicks as an extreme), or would it be better just to bite the bullet and go
for 108mm cv's straight away?.
Ian
I think you have answered your own question, do it once and do it right
Saw your car at Stoneleigh, I was parked a couple of cars away. Very impressive build
I saw yours, shame you wasn’t around to see the engine 
And the op’s Duratec 30 Metro behind was awesome.
What’s the gearbox
[Edited on 5/5/19 by big_wasa]
|
|
|
Oddified
|
| posted on 5/5/19 at 07:20 PM |
|
|
I thought someone would say that! lol, and to be fair your probably right, just go for the 108mm and be done with it.
I was around the show all day and went back to the car from time to time but getting away again from the car and all the questions was a challenge!.
It'll be back on rawcus pitch again tomorrow.
The gearbox is an Audi 012 (in many Audi A4's 5's etc etc), quite commonly used now as a transaxle in mid engined kits/specials. The same
as used by Speed3 in their 6r4 rep and also the RS Retro RS200 replica at the show.
Ian
|
|
|
rusty nuts
|
| posted on 5/5/19 at 07:34 PM |
|
|
I’m at Stoneleigh at the moment, saw your car earlier as others have said . I rather liked the 100e sitting near yours
|
|
|
.jpg)
