harmchar
|
| posted on 11/10/21 at 05:32 PM |
|
|
Prep pinto head for new carbs and photo upload trial
Head off for valve lapping and prep for ZZR1100 carbs. Ditching Weber 32/36.
This is also a trial to see if photo uploads
 
Description
[Edited on 11/10/21 by harmchar]
|
|
|
|
|
harmchar
|
| posted on 11/10/21 at 05:46 PM |
|
|
See if this works
Description
[Edited on 11/10/21 by harmchar]
[Edited on 11/10/21 by harmchar]
|
|
|
jacko
|
| posted on 11/10/21 at 07:49 PM |
|
|
Hi is the pinto a 2.1 all ready or are you. Giving the engine the full works
Jacko
|
|
|
harmchar
|
| posted on 11/10/21 at 09:32 PM |
|
|
Had problems getting engine to idle and run on the Weber 32/36. Did a partial rebuild and clean, still wouldn't idle proper. Did a compression
test and cyls 2 & 3 were really low. After removing rocker cover, 2 & 3 inlet rockers were hanging off because the adjusters were slack. Got
me wondering what else had not been done properly by last owner so made the choice to remove the head to see what was going on. Head gasket looked
okay but valves looked gummed up with carbon and oil. Going for complete refresh now. ZZR1100 carbs turned up in the post today, but have a few parts
missing that will slow progress again. Good winter project as won't be putting car through IVA until spring now.
|
|
|
