grahamgg
|
| posted on 4/3/07 at 03:45 PM |
|
|
zetec to type 9
Just mated gearbox with engine,looks like the release bearing i ordered is the wrong one.
I am using zetec pressure plate,pinto friction plate,(and what i thought i ordered) a capri release bearing if i remember correctly....
Has anyone got the capri release bearing handy so they can measure the height..i seem to be about 1.5 to 2cm short..i think the parts store has given
me a sierra release bearing which is about 3.5cm high..any part no's would be handy.thanks
|
|
|
|
|
bob
|
| posted on 4/3/07 at 04:02 PM |
|
|
CCT 133 release bearing
The whole bearing top to bottom measures 41mm.
I just dropped zetec in yesterday and bolted up to a type 9,1800 flywheel and early mondeo 220mm clutch kit.
Throw of the pivot arm on the gearbox looks pretty much like the distance i had with the pinto.
Hope this helps
[Edited on 4/3/07 by bob]
|
|
|
Danozeman
|
| posted on 4/3/07 at 04:18 PM |
|
|
Yep cct133 release brg. I have zetec flywheel, zetec 1.8 clutch and capri releaase brg. works a treat.
I did have a problem with the bell housing being to long to start with so i had to change the box. Are u sure u have a standard bell housing??
Dan
Built the purple peril!! Let the modifications begin!!
http://www.eastangliankitcars.co.uk
|
|
|
grahamgg
|
| posted on 4/3/07 at 04:18 PM |
|
|
thanks for that..you couldn't help me with the other question i posted earlier today titled "help need some measurements"
what size is a standard bellhousing???
[Edited on 4/3/07 by grahamgg]
|
|
|
Dusty
|
| posted on 4/3/07 at 05:13 PM |
|
|
Pic found of QH CT133
I have used a zetec 1800 flywheel drilled for uprated pinto diaphragm and friction plate and it uses the standard sierra release bearing.
[Edited on 4/3/07 by Dusty]
 
Rescued attachment caprirelease.JPG
|
|
|
rusty nuts
|
| posted on 4/3/07 at 05:26 PM |
|
|
quote:
Originally posted by grahamgg
thanks for that..you couldn't help me with the other question i posted earlier today titled "help need some measurements"
what size is a standard bellhousing???
[Edited on 4/3/07 by grahamgg]
From the engine mounting surface to the gearbox mounting surface is 7" or 178mm for the standard type 9 IIRC on the deisel and v6 boxes it is
about 200mm
|
|
|
grahamgg
|
| posted on 4/3/07 at 05:31 PM |
|
|
yeah mines 7" so must be release bearing mine is only 33mm
|
|
|
bob
|
| posted on 4/3/07 at 07:59 PM |
|
|
Thats about right then, i think i posted somewhere else that the cct133 capri 1300 release bearing stands about 8mm longer than the normal sierra
bearing.
|
|
|
.jpg)
