mickebo
|
| posted on 6/9/08 at 03:20 PM |
|
|
Sierra LSD again
Looked around here for the possibility to use non LSD driveshaft on my "new" LSD.
Found no real solution.
I have a non LSD on the car, it´s a 3,62 from a 2,0DOCH -92 Sierra, got a 3,62 LSD from a Sierra Cossie ca -91. Got extra shafts from 2,DOCH but no
Cossie ones.
Same diameter and splines inside the diff but different length - no fit!
Found out that there are 25 splines on a non LSD shaft (the shaft not joint) and 25 splines inside a Granada/Scorpio inner/outer joint. And they
fitted perfectly!
Just bought 1 used Scorpio shaft cause inner and outer joint is the same one.
Now I had 2 Driveshafts with outer tripodjoints and screwed inner joints. And it seems all lengths are ok.
Winter project will be to fit the LSD without removing driveshafts from my new wheelbearings, just to change the innerjoints.
 
Rescued attachment knudan.jpg
|
|
|
|
|
mickebo
|
| posted on 6/9/08 at 03:21 PM |
|
|
No fit
 
Rescued attachment splines.jpg
|
|
|
mickebo
|
| posted on 6/9/08 at 03:22 PM |
|
|
Same thickness on tripod vs joint
 
Rescued attachment tripodvsknut.jpg
|
|
|
mickebo
|
| posted on 6/9/08 at 03:23 PM |
|
|
Fit great on splines
 
Rescued attachment trans.jpg
|
|
|
mickebo
|
| posted on 6/9/08 at 03:25 PM |
|
|
Think I will use the spring from the tripod to position the joint
 
Rescued attachment fjäder.jpg
|
|
|
mickebo
|
| posted on 6/9/08 at 03:26 PM |
|
|
2 "new" shafts and som maybe useful scrap?
 
Rescued attachment klart.jpg
|
|
|
mickebo
|
| posted on 6/9/08 at 03:26 PM |
|
|
Measuring
 
Rescued attachment mäta.jpg
|
|
|
mickebo
|
| posted on 6/9/08 at 03:27 PM |
|
|
After some refurbishing it´s going to sit here!
 
Rescued attachment påbilen.jpg
|
|
|
Volvorsport
|
| posted on 6/9/08 at 03:43 PM |
|
|
are you from sweden ?
whats the diameter and spline count in the diff - is it 25 ?
youve got a 7.5inch diff ,how many bolts does teh crownwheel bolt to the diff housing with ?
do you have a dimension from the crownwheel face to the bearing race ?
www.dbsmotorsport.co.uk
getting dirty under a bus
|
|
|
MikeR
|
| posted on 6/9/08 at 03:45 PM |
|
|
where are you based? I could be interested in your left over bits for my de-dion install. I'm having to have shafts made up and any spares in
case the job goes wrong would be appreciated.
|
|
|
mickebo
|
| posted on 6/9/08 at 03:51 PM |
|
|
Yes I´m in Sweden.
No it´s a 7inch diff.
To far MikeR?
|
|
|
Volvorsport
|
| posted on 6/9/08 at 05:30 PM |
|
|
well the big question was , if its a 10 blot CWP , it may be able to modify it to my volvo rear axle , altho that has 27 spline dana 30 .
www.dbsmotorsport.co.uk
getting dirty under a bus
|
|
|
MikeR
|
| posted on 6/9/08 at 06:11 PM |
|
|
quote:
Originally posted by mickebo
Yes I´m in Sweden.
No it´s a 7inch diff.
To far MikeR?
Got friends in Helsinki and Oulu, may pop round when i next go to see them 
(ok, its too far)
|
|
|
mickebo
|
| posted on 6/9/08 at 08:21 PM |
|
|
quote:
Originally posted by Volvorsport
well the big question was , if its a 10 blot CWP , it may be able to modify it to my volvo rear axle , altho that has 27 spline dana 30 .
10 blot CWP?
What Volvoaxel are you using?
You want to fit a Sierra LSDunit in your Volvoaxel?
Number of bolts and diam. of crownwheel?(maybe 7inch)
Number of splines into diff + diam.?
I don´t understand this:
"do you have a dimension from the crownwheel face to the bearing race ?"
I´ll goto my workshop tomorrow and check it, i´ll be back.
|
|
|
mickebo
|
| posted on 7/9/08 at 11:04 AM |
|
|
quote:
Originally posted by Volvorsport
well the big question was , if its a 10 blot CWP , it may be able to modify it to my volvo rear axle , altho that has 27 spline dana 30 .
10 blot CWP?
What Volvoaxel are you using?
You want to fit a Sierra LSDunit in your Volvoaxel?
Number of bolts and diam. of crownwheel?(maybe 7inch) 10 bolts
Number of splines into diff + diam.? 26 splines ca 28,5 mm
I don´t understand this:
"do you have a dimension from the crownwheel face to the bearing race ?" maybe 35 mm
Look in my photoarchive, rearendbook might be some tips.
Why did you believe I was Swedish?
[Edited on 2008/9/7 by mickebo]
|
|
|
