Slater
|
| posted on 23/10/08 at 08:46 AM |
|
|
Zetec Block/Exhast Header Pipe Gasket
I have an block / exhaust header pipe gasket for my zetec, it's two thin sheets of pressed steel spot welded together.
My question is... do I assemble this dry or should I be using a sealant material of some kind? Any recomendations?
Keith.
Why do they call Port Harcourt "The Garden City"?...... Becauase they can't spell Stramash.
|
|
|
|
|
r1_pete
|
| posted on 23/10/08 at 08:56 AM |
|
|
The manual doesn't specify any sealant, I assembled mine dry, the one I took off had been dry assembled, seems to be ok, but only had a short
run - no coolant.
BTW mines a blacktop.
|
|
|
SeaBass
|
| posted on 23/10/08 at 09:01 AM |
|
|
It was dry on the OE install of the engine and I've installed it dry on my Zetec Ph3 to Westfield manifold. Doesn't blow...
|
|
|
Danozeman
|
| posted on 23/10/08 at 04:36 PM |
|
|
Yep should be dry.
Dan
Built the purple peril!! Let the modifications begin!!
http://www.eastangliankitcars.co.uk
|
|
|
