Hi
fitting water temp gauge on R1 carb model. Where is best to take the water temperature from. Where to locate the sender.
Many thanks
Where it exits the engine for a gauge, so if you cannot plumb just before the thermstat then fit in the top hose.
just before it goes into the rad. (not out)
Yes a gauge should go in the engine water outlet before the thermostat if that is not suitable anywhere in the cylinder head, or in
the coolant by-pass circuit
[Edited on 26/1/12 by britishtrident]
Many thanks everyone
Hi
This is the layout we used & works perfectly.
(See waterworks sketch on our photo archive)
Hope it helps.
BEST PLACE IS JUST BEFORE THE WATER ENTERS THE RADIATOR