FOSSIE
|
posted on 17/4/24 at 04:53 PM |
|
|
Wanted - 7" Sierra Diff
I'm after a 7" Sierra diff please - non LSD type preferably.
Ideally 3.4:1 - 3.6:1 range but not too fussed - as long as it's complete and undamaged.
Many thanks
Tom
|
|
|
Dingz
|
posted on 17/4/24 at 10:06 PM |
|
|
I have a complete Sierra rear beam with 3.38 open diff. Depends where you are but I’m open to offers?
Phoned the local ramblers club today, but the bloke who answered just
went on and on.
|
|
FOSSIE
|
posted on 18/4/24 at 08:40 AM |
|
|
Thanks Dingz, I've sent you a PM.
|
|
MikeR
|
posted on 18/4/24 at 10:08 AM |
|
|
I've got a 3.6 diff but ..... its the 6" version. Same case as the 7" so fits all the same mountings but a slightly lighter diff as
fitted to the 1300's.
(insert here bits about rotating mass, lower weight, improved performance).
Its push in shaft and i've got the joints, but you'd need to get the drive shaft made up.
Based near Hinckley. I've been kicking it around for years so happy to sell it for a 'good' price to get it out of the way.
|
|
FOSSIE
|
posted on 18/4/24 at 10:25 AM |
|
|
That's interesting Mike, funnily enough I am looking for a new 7" diff to replace the 6" diff that I've just removed! I have
worked with diffs for 20+ years and didn't know these existed until last week.
When you say you have the joints... Can you elaborate? The main reason for wanting a new/replacement 7" diff was so that I could get some new
shafts - as it would seem new 23spline shafts are non existent. If I could rebuild my current, 23 spline shafts then I perhaps don't need a new
diff.
PM outside of this thread if you prefer.
Many thanks
Tom
|
|