ok...after all that
Is there anyone with a design for a compliant roll cage that can be bolted/welded to a completed chassis ?

[Edited on 17/10/10 by alawrence]

This is what I will be looking into over the winter too,I think welderman sells them...well I hope he still does might be worth sending him a msg,let me know if you sort something else.

This is what I will be looking into over the winter too,I think welderman sells them...well I hope he still does might be worth sending him a msg,let me know if you sort something else.

The design is in the MSA blue book, as long as you follow this to the letter you will be okay.

I havent had much luck understanding the blue book..

it says the front legs must be straight and then pic 3 & 4 have bends in them..

this is what i want..





front hoop straight at the bottom and then a small kick backwards..

and bend in the roof bars for better access... is this allowed

[Edited on 17/10/10 by gavin174]

i know its got to be to the book
but im not going to be mking it and im not to concerned about the detail...
i just want one ........

i will be having a clear out soon, will shufty through all the bits of cages ive got

Weldeman are you still making cages? I have a Indy with a hoop no rear struts and would like a full cage like the MK one does not have to be to the blue book regs do you sell them in kits to weld/bolt in?

yes, have some left if your not bothered about the regs mate, can make it weld in of bolted to your spec


Joe

cool! ill be intouch when i know what i want any idea of prices for what i have decribed pls.