Just like to say ive finally got some photos of my Indy on the forum. If anyone is interested they are there for you to view. Jacko.

Nice one, Looks ace, i like the air filter. Where abouts are you from, i work in brough and know a couple of builders in hull. Did you have any difficulties with beverly SVA?

very nice ........ top job

Proper job!

I'm tempted by SUs. Are they HIF8s from a Rover V8?
And is the manifold commercial or did you (and would I have to) fabricate it?

Don't know if anyone would be interested but I'm currently making a pinto inlet manifold for a friend to run a set of 38 mm Mikuni carbs from a GSXR. Just waiting for the tig welding to be done.

Once I've made sure she runs ok and done a bit of devolpment work on the jetting I would be happy to knock out a couple more manifolds for board members perhaps at material cost + a little bit for my time?

GSXR carbs can be had on ebay for about 40 quid. So a whole setup for £120ish?

Got to be cheaper than 45s which mostly only run 36mm chokes.

I will keep you updated when she hits the dyno.
Any interest?

yellow ,thanks for that knew i'd seen a nother colour of warning light but just couldn't rember what it was
tony

Yellow great colour (mines yellow with polished ali ) Make it easy to see on the road dont know how easy to keep clean yet.