Hi All,

I've got a couple of problems with my MK exhaust:

1 .. The rivets holding the end of the can on have all come loose, can anyone tell me the size these rivets should be (where I can get them would be even better)

2 .. The exhaust silencer is sitting too low I think, it sit about an inch or more below the chassis, mainly due to the angle I've got my engine at.



Exhaust 1


Exhaust2
So my question is, is it sitting too low and how can I adjust it?


[Edited on 3/9/06 by phoenix70]

We adjusted ours by cutting a V out of the weld where it becomes horizontal, bent it up and then had it re-welded

Better come over to the mgw to have a looky
Ps the rivits are here and you can use the bling air one to set them