Hi Guys.

This is my situation:
I am attempting to use some enclosed bodywork on my MK Indy chassis. The wheels I have at the moment are for a lotus 340r which I would really like to use, I have had some hub adaptors made to fit these to the sierra hubs/uprights.
Fronts are 195s rears are 225s.
However the wheels stick out from the bodywork by about 20mm each side.
What I could do with is borrowing a sierra offset wheel (if it's the same at the back as the front, if not I need a front and a rear) to see if it will sit under the bodywork.

If anyone can lend me the required wheels I would be very thankful. I can collect or if you would prefer to be present then thats fine too. I live near Bleasby Notts.

Cheers.
Steve.

[Edited on 19/7/07 by Hammerhead]

Hi Steve,
Is that Bleasby near Southwell? Didn't realised you were so close I've got 5 sierra steel wheels sat in my garage in Bingham. You're more than welcome to come over and borrow what you need. I'll U2U my address.

Cheers,
Bill

Thanks Bilbo for the U2U.

Yes Bleasby near Southwell. Interesting that you are using a Rover engine too!

Is saturday between 4:30 - 5 be OK for you?

Cheers.
Steve.

I'm seeing my folks on Saturday afternoon, but I should be back by 5:30 - 6 if that's OK? Alternatively, I'll be in all day Sunday.

Cheers,
Bill