Board logo

MK seats and runners *sigh*
Jonte - 3/1/08 at 09:24 PM

I must check some things about the runners and seats from MK

If I measure the distance between the holes in the runners its 330mm, but when I measure the runner fixings in the seats itīs 310mm



Is this how it is for everyone and you just redrill the runners?


Then I probably have to make some 10mm brackets under the runners

StevieB - 3/1/08 at 09:56 PM

That's pretty much what I've done.

I used some 12mm thick rubber washers I picked up at an autojumble as spacers - should take a little of the vibration of of the seat too.

Wouldn't it be nice f a little forethought to these little things was displayed by the manufacturers?

[Edited on 3/1/08 by StevieB]

Avoneer - 3/1/08 at 09:59 PM

But the vibrations are nice ;-)

Yep - ovalate or re-drill the holes.

Pat...

Hellfire - 4/1/08 at 07:16 AM

quote:
Originally posted by Avoneer
But the vibrations are nice ;-)

Yep - ovalate or re-drill the holes.

Pat...


Concurr with what Pat says - but dont read it as ovulate, you dont want one more bad tempered person in the house...

Steve

scotlad - 4/1/08 at 08:08 AM

Quote-

'Concurr with what Pat says - but dont read it as ovulate, you dont want one more bad tempered person in the house... '

Ha Ha Thats what i thought of too- ones enough for me!!!!

ASH3 - 4/1/08 at 10:42 PM

More holes in the floor the better



[Edited on 4/1/08 by ASH3]

Jonte - 6/1/08 at 07:18 PM

well I guess you were lucky or you donīt remember it correctly . But the holes on my runners are the same distance on both sides.

pawgrp - 8/1/08 at 02:23 PM

Hi Jonte,

There is a mark on the runner which just happens to be the right distance for the hole centers for the seat. Just run a tape along it from one of the pre drilled holes and I'm sure all will become obvious.
Paul

Peteff - 8/1/08 at 05:03 PM

or a mixture of both?